Royal Swimming Pools Hot Tubs, Saunas, Games, and More

866-532-8194

In-Ground Cover Installation Instructions

1. Be sure to buy the right size cover for your pool. You should not stretch your pool cover across the pool in an attempt to make it fit. Refer to the diagram 1.
Inground Cover Installation

Inground Cover Installation

 
 
 2. Covers from Royal Swimming Pools are made to have rain water accumulate on top of them. This water will not damage your cover. Excessive water can be periodically pumped from the cover, but be sure to leave approximately 1 inch of water to protect the cover from wind damage. Be sure not to place the cover pump on a seam when draining water, as this will cause water from your pool to be drained.

 3. Royal Swimming Pools covers will accommodate a maximum 18 inch water drop below the top edge of your pool. If you normally drop your water more than 18 inches, you should order a larger size cover. Refer to diagram 1 for proper fit.
 4. Do not use bricks or sharp blocks to weigh your cover down. Royal Swimming Pools recommends using water tubes  for in-ground pools.
 5. If you tie your cover to a fence or other permanent structure, be sure to use a flexible bungie cord. This will allow the cover to shift as snow and ice accumulate without pulling out the corner tabs or straps. Water tubes must still be used.

 Please order your cover by pool size including step! (Royal Swimming Pools covers accommodate an 18-inch water drop.)

 

Share on Facebook1Tweet about this on TwitterPin on Pinterest0Share on Google+0Share on LinkedIn0Email this to someone

Leave a Reply

Your email address will not be published. Required fields are marked *